![]() Volkswagen Jetta SportWagen in Tennessee, United States May 2013 - Feb 2015 Connect battery ground cable and check the operation of the speedometer.Install the instrument cluster as outlined.Position the instrument cluster mask and instrument cluster main lens to the instrument cluster back plate and install the seven retaining screws.Position the speedometer assembly to the instrument cluster back plate (10848) and install.Remove seven screws retaining the instrument cluster mask (10890) and instrument cluster main lens (10887).Remove the instrument cluster (10849) as outlined.Since the speedometer mileage cannot be reset on this unit, affix odometer sticker to driver's door pillar and record original vehicle mileage. įederal law requires that the odometer in any replacement speedometer (17255) must register the same mileage as that registered in the removed speedometer. Remove the instrument cluster from the instrument panel (04320).Slide the instrument cluster (10849) to the right of the instrument panel opening and unhook the instrument panel harness from the back of the instrument cluster.(Do not remove screws from the instrument cluster main lens (10887) and instrument cluster mask (10890) ). ![]() Remove four instrument cluster retaining screws.Remove fasteners holding the instrument panel finish panel (044D70) and gently pry off. ![]() Remove fasteners holding steering wheel column as outlined in Section 11-04.Remove screws holding instrument panel lower shield (045G02).Remove screws holding instrument panel reinforcement (017A28).Disconnect battery ground cable (14301).Section 13-01: Instrument Cluster-Conventional Your best bet, take it to a qualified repair shop. If the instrument cluster is replaced, the mileage stored in the BCM will be sent to the new cluster via serial data, and shown in the odometer display. Replacement instrument clusters do not require odometer pre-setting before installation. For replacement of the BCM refer to the BCM section of this service manual. If the BCM fails, the cluster will display the last valid mileage that was sent before the BCM failed. The body control module (BCM) stores the vehicle mileage. The trip odometer has four digits including a decimal point and indicates tenths of a mile or kilometer. ![]() ![]() The total odometer display has six digits with no decimal display. To reset the trip odometer, push and hold the button down for at least two seconds. The push button in the lower right side of the speedometer is used to toggle between the trip and total odometer readings. The trip odometer and total odometer will show in this display area. The odometer backlight bulb brightness is controlled by class 2 messages from the BCM to adjust the display for daylight and instrument panel dimming operation. Digits displayed are illuminated by the odometer backlight bulb. The odometer is an electronic digital display. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |